Unitec Receipt Printer User Manual download pdf

WASHPAY

Document Number: WP1007

Receipt Printer Installation Instructions

The WashPay Receipt Printer should be centrally located and visible from all wash bays. Since the printer is

operator-accessible from the rear, the ideal location would be in the vicinity of the bill changer. The Receipt Printer

will be recess-mounted into a pre-cut hole using L-brackets.

Receipt Printer Specifications

Dimensions, Enclosure 7” W x 16” H x 12.1” D

Dimensions, Front Panel 10” W x 19” H

Weight 29 lbs

Enclosure Stainless Steel

Power 110-220VAC, 50-60Hz

Wiring CAT5E Cable

Important:

The WashPay Receipt Printer enclosures must be connected to earth ground.

Follow the steps below to install the Receipt Printer:

1. Disconnect all power routing to existing equipment.

2. Using the Receipt Printer dimensions shown in the following figure, determine where to mount the Receipt

Printer. Make sure the mounting location is a solid surface.

3. Cut a hole for the Receipt Printer in the wall using the dimensions in the following figure.

4. Slide the Receipt Printer into the space you have created in the wall of the building. The back access door

will be inside of the building while the printer faces outside.

Figure 1. WashPay Receipt Printer Dimensions

Document Title: WashPay Receipt Printer Installation Instructions

1 2

Page 1

WASHPAY Document Number: WP1007 Receipt Printer Installation Instructions The WashPay Receipt Printer should be centrally located and vis

WASHPAY Document Number: WP1007 5. Be sure that the flange on the front of the printer is flush with the wall. 6. Align the 1" sid

No comments

Unitec Receipt Printer User Manual