Unitec WashPay Card Terminal Retrofit User Manual download pdf

WASHPAY

Document Number: WP1004 1

WashPay Card Terminal Retrofit Installation

Instructions

The Card Terminal will be installed in each wash bay. It contains a paynode, card reader,

circuit board, and Stop button. The Card Terminal comes with four pre-drilled holes in the

back of the enclosure, allowing it to be surface-mounted, or it can be recess-mounted into a

pre-cut hole in the wall of the wash bay. The WashPay Card Terminal is powered from the

24VAC power from the existing equipment in the wash bay.

Card Terminal Specifications

Dimensions 10.63” W x 7.56” H x 3.28” D

Weight (approximate) 11 lbs

Power 24VAC, 60Hz

Enclosure Stainless Steel

1 Installation of Card Terminal Box

Follow these steps to install the WashPay Card Terminal:

1. Disconnect all power routing to existing equipment.

2. Using the Card Terminal dimensions shown in

Figure 1, determine where to mount

the Card Terminal. Make sure the mounting location is a solid surface

3. Mount the Card Terminal by either attaching it to the wall surface or recess-mounting

it into a pre-cut hole (determined by the dimensions in

Figure 1).

4. Run the timer, coin input/output, and 24VAC wires from the existing coin meter box to

the card terminal.

Figure 1. WashPay Card Terminal Dimensions

Document Title: WashPay Card Terminal Retrofit Installation Instructions

1 2 3 4 5 6

WASHPAY Document Number: WP1004 1 WashPay Card Terminal Retrofit Installation Instructions The Card Terminal will be installed in each was

WASHPAY Document Number: WP1004 2 2 Wiring Connections Important: Follow local electrical codes! Equipment Needed: • Small Screwdrive

WASHPAY Document Number: WP1004 3 Figure 3. Rev C Power Board Pin-Out Configuration Table 1. Jumper Settings Jumper Settings Jumper 1 Re

WASHPAY Document Number: WP1004 4 Document Title: WashPay Card Terminal Retrofit Installation Instructions

Page 5

WASHPAY Document Number: WP1004 5 Document Title: WashPay Card Terminal Retrofit Installation Instructions 2.1 Connecting to a Dixmor T

WASHPAY Document Number: WP1004 6 Document Title: WashPay Card Terminal Retrofit Installation Instructions 5. Locate the Coin Input wire

No comments

Unitec WashPay Card Terminal Retrofit User Manual