Unitec C-Start Installation Manual User Manual

Browse online or download User Manual for Equipment Unitec C-Start Installation Manual. Unitec C-Start Installation Manual User Manual

  • Download
  • Add to my manuals
  • Print

Summary of Contents

Page 1

C-Start Installation Manual Unitec 443-561-1200 • www.StartwithUnitec.com

Page 2 - C-START INSTALLATION MANUAL

C-START Document Number: CST1001 6 2.3 Base Installation  Note: Pull all wires through conduits before mounting the base. See Electri

Page 3

C-START Document Number: CST1001 7 2.4 Mounting the C-Start 1. Rest the C-Start enclosure on top of the base and feed the wires throu

Page 4 - Index of Figures

C-START Document Number: CST1001 8 3.2 Connecting Power 1. Route the main power wires to the AC terminal strip on C-Start’s power pa

Page 5

C-START Document Number: CST1001 9 3.3 Wash Control Wiring 3.3.1 Overview In applications where the C-Start will communicate with the W

Page 6

C-START Document Number: CST1001 10 3.3.2 Wiring the Wash Relay Interface To wire the wash relays, remove the screw terminal plug from

Page 7 - 1.2 Electrical

C-START Document Number: CST1001 11 Document Name: C-Start Installation Manual  Note: Wash equipment wiring may vary, and not all equip

Page 8 - 1.2.3 Wiring Requirements

C-START Document Number: CST1001 12 Document Name: C-Start Installation Manual intercom wiring is sharing conduit with other communicati

Page 9 - 2 Installation

C-START Document Number: CST1001 13 Document Name: C-Start Installation Manual 4 System Startup For fully detailed instructions, please

Page 10 - 2.3 Base Installation

C-START Document Number: CST1001 14 Document Name: C-Start Installation Manual [THIS PAGE INTENTIONALLY LEFT BLANK]

Page 11 - 3 Electrical Connections

C-START Document Number: CST1001 15 Appendix A - POS Interface Option The external POS option allows wash codes to be purchased at Point

Page 12 - 3.2 Connecting Power

C-START Document Number: CSTART1001 Document Name: C-Start Installation Manual C-START INSTALLATION MANUAL This manual provides installati

Page 13 - 3.3 Wash Control Wiring

C-START Document Number: CST1001 16 Appendix B - C-Start Networking Unitec supplies a pre-programmed router for connecting devices as a lo

Page 14 - Pin Signal

C-START Document Number: CST1001 17 Third party devices should not be connected directly to the Unitec router. The broadband device sup

Page 15 - 3.5 Intercom Systems

C-START Document Number: CST1001 18 Appendix C – Terminating Ethernet Cables 1. Carefully remove the outer jacket of the cable. Be care

Page 16 - 3.5.4 Connection Overview

C-START Document Number: CST1001 19 4. Arrange the wires in the following order (from left to right): • white/orange • orange • whi

Page 17 - 5 System Test

C-START Document Number: CST1001 20 7. Place the wired plug into the crimping tool. Give the handle a firm squeeze. You should hear a

Page 18 - C-START

C-START Document Number: CST1001 i Document Name: C-Start Installation Manual Table of Contents 1 Site Planning and Preparation ...

Page 19

C-START Document Number: CST1001 ii Document Name: C-Start Installation Manual Index of Figures Figure 1. C-Start Position...

Page 20 - C-START

C-START Document Number: CST1001 1 1 Site Planning and Preparation This chapter provides guidelines for positioning the C-Start and pre

Page 21

C-START Document Number: CST1001 2 1.1 Positioning the C-Start When installed at the wash entrance, the C-Start should be located at

Page 22

C-START Document Number: CST1001 3 Document Name: C-Start Installation Manual 1.2 Electrical 1.2.1 Power Requirements C-Start requires

Page 23

C-START Document Number: CST1001 4 Figure 2. Conduit Runs 1.2.3 Wiring Requirements Wiring requirements are summarized in the following

Page 24

C-START Document Number: CST1001 5 Document Name: C-Start Installation Manual 2 Installation 2.1 Installation Hardware Prior to beginnin

Comments to this Manuals

No comments